- Speaker and headphone calibration software and measurement microphone in a bundle
- Precise adjustment of the frequency response to get flat and neutral sounding monitor speakers or headphones
- Enables a more precise evaluation of recordings and mixes
- Room analysis and automated calculation of the room size based on several measurements
- Audio calibration engine allows for accurate processing
- Save an unlimited number of calibration profiles for monitor speakers
- Comes with headphone calibration profiles for more than 280 supported models
- Target curve custom adjustments in real time
- Translation check simulates over 20 different devices and device types for accurate mix translation results
- 3 filter modes to choose from: Zero Latency, Mixed and Linear Phase allow to optimize filter quality and latency according to the monitoring situation
- Additional processing controls for Mono, Dry/Wet and Safe Headroom
- App only: MIDI mapping for various controls and user presets for predefined output device/channel pair combinations
- Measurement microphone with a pre-polarized electret-condenser capsule
- Frequency response: 20 - 20.000 Hz with calibration curve
- Omnidirectional polar pattern
- Sensitivity: 14 mV/Pa
- Self noise: 24 dB
- Signal to noise ratio: 70 dB
- Dynamic range: 106dB
- Maximum sound pressure level: 132 dB SPL
- Requires 48 V phantom power
- Connector: 3 pin XLR
- Microphone calibration file for 30° off-axis measurements in Sonarworks software native format to be used with SoundID Reference
- Microphone calibration file for 0° on-axis measurements in .txt format